The A3 Lucipac test is a top-of-the-line hygiene testing system, which detects contamination within 10 seconds. Just one swap and it detects ATP, ADP and AMP to give you the whole picture. But how exactly does it work? What do you need to do with it?
Firstly, clean the equipment as normal, then we start our test. Grab the A3 Lucipac tube with the green handle and take the swab out. Swab the surface you want to test.
Make sure that when swabbing:
To have the swab slightly bent to use its entire surface area,
To swab a 10cm x 10cm surface as the picture below indicates.
After swabbing, insert the swab back into the tube, making sure to push the top all the way down. Then, shake the tube until liquid interacts with the sample at the bottom of the tube. The reagents should be completely dissolved. Then, while holding the Lumitester upright, slide the tube into the Lumitester, close it and press “enter”. After 10 seconds the number of RLU’s will come up on the screen, if that number is greater than 500 then the surface must be recleaned until the number is below 500, which indicates a clean surface.
Results can be analyzed and visualized with the paired app. More details on this as well as a full in-depth guide can be found in the video below.
To prevent dirt from spreading within production and logistics halls, it is collected in a collecting tray under the cleaning mats.
Choosing the right tub height depends on three crucial factors:
Requirements
Before making a decision, it must be clear what the site looks like, whether cleaning should take place inside, outside or both, and how wide the passageways are.
Vehicles and frequency
Which vehicles cross the clean-walking zone? Do shoe treads also need to be cleaned? How many crossings are made per day? If the frequency is higher, we recommend using a deeper tray because more dirt can be collected.
Maintenance intervals
The deeper the tray, the more dirt can fit in it and the longer the cleaning interval. This saves you work because the drip trays need to be cleaned less often.
Customizable Sampling Plans
Users, sampling plans, and test points can all be configured through the Lumitester Smart app, including pictures of each specific test point
Bluetooth Connectivity
Exportable Data and Reports for Regulatory Compliance
Export your data to a .csv file for easy analysis and data retention designed to meet regulatory compliance
Patented Technology for Enhanced Sensitivity
See how A3 technology finds what ATP technology can’t
Firstly, clean the equipment as normal, then we start our test. Grab the A3 Lucipac tube with the green handle and take the swab out. Swab the surface you want to test.
Make sure that when swabbing:
After swabbing, insert the swab back into the tube, making sure to push the top all the way down. Then, shake the tube until liquid interacts with the sample at the bottom of the tube. The reagents should be completely dissolved. Then, while holding the Lumitester upright, slide the tube into the Lumitester, close it and press “enter”. After 10 seconds the number of RLU’s will come up on the screen, if that number is greater than 500 then the surface must be recleaned until the number is below 500, which indicates a clean surface.
Results can be analyzed and visualized with the paired app. More details on this as well as a full in-depth guide can be found in the video below.
Exportable Data and Reports for Regulatory Compliance
See how A3 technology finds what ATP technology can’t